ANALISIS STABILITAS DINDING PENAHAN TANAH BETON DENGAN MEMPERHITUNGKAN BEBAN GEMPA MENGGUNAKAN METODE MONONOBE-OKABE (STUDI KASUS: PROYEK PEMBANGUNAN JALAN LINGKAR BARAT UGM) CONCRETE WALL STABILITY ANALYSIS BY CALCULATING THE LOAD OF EARTHQUAKES USING MONONOBE-OKABE METHOD (CASE STUDY: UGM WEST RING ROAD DEVELOPMENT PROJECT)

Kusyanto, Imannudin and Ismaili, Abul Fida (2020) ANALISIS STABILITAS DINDING PENAHAN TANAH BETON DENGAN MEMPERHITUNGKAN BEBAN GEMPA MENGGUNAKAN METODE MONONOBE-OKABE (STUDI KASUS: PROYEK PEMBANGUNAN JALAN LINGKAR BARAT UGM) CONCRETE WALL STABILITY ANALYSIS BY CALCULATING THE LOAD OF EARTHQUAKES USING MONONOBE-OKABE METHOD (CASE STUDY: UGM WEST RING ROAD DEVELOPMENT PROJECT). Tugas Akhir thesis, University Technology Yogyakarta.

[img]
Preview
Text
5130811010_IMANNUDIN KUSYANTO.pdf

Download (290kB) | Preview

Abstract

ABSTRAK Untuk memaksimalkan penggunaan lahan yang berada di derah lereng perlu adanya perhitungan faktor keamanan terhadap longsoran. Longsoran adalah suatu bencana alam yang dapat didefinisikan sebagai pergerakan tanah mengikuti bidang gelincir akibat dari bertambahnya masa tanah. Tujuan dari penelitian ini adalah untuk mengetahui faktor keamanan lereng yang berada di Proyek Pembangunan Jalan Lingkar Barat UGM dan perencanaan dinding penahan tanah sebagai perkuatan pada lereng. Metode yang digunakan untuk perhitungan faktor keamanan lereng adalah metode Fellinius (1927). Hasil dari perhitungan faktor keamanan dengan R = 6.6 m didapatkan angka keamanan sebesar F = 0.97, dengan angka tersebut maka dapat dikategorikan sebagai lereng mudah longsor. Sebagai perkuatan pada lereng digunakan dinding penahan tanah dengan dimensi H = 6.8 m, B = 3.8 m. Perhitungan stabilitas dinding penahan tanah dihitung dengan 3 kondisi. Pada kondisi normal tanpa beban tambahan didapatkan nilai keamanan terhadap guling (Fgl) = 3.72 > 2 dan nilai keamanan terhadap geser (Fgs) = . Pada kondisi normal dengan beban tambahan nilai faktor keamanan terhadap guling (Fgl) = 3.32 > 2 aman, faktor keamanan terhadap geser (Fgs) = 2.53 > 1.5 aman. Pada kondisi gempa didapatkan faktor keamanan terhadap guling (Fgl) = 2.19 > 1.25 aman, faktor keamanan terhadap geser (Fgs) = 1.27 > 1.25 aman. Untuk faktor keamanan terhadap keruntuhan didapatkan angka keamanan sebesar 5.53 > 3 aman. Penulangan pada dinding penahan didapatkan untuk tulangan pokok memakai D25~250 dan untuk tulangan bagi memakai D16~200. Kata kunci: Dinding penahan tanah, Lereng, Metode Fellinius. ABSTRACT To maximize the use of land on the slopes, it is necessary to calculate the safety factor against landslides. Landslide is a natural disaster which can be defined as the movement of the land following the slip plane due to the increase in land mass. The purpose of this study was to determine the safety factor of slopes in the UGM West Ring Road Development Project and to plan retaining walls as reinforcement on slopes. The method used to calculate the slope safety factor is the Fellinius method (1927). The results of the calculation of the safety factor with R = 6.6 m, the safety number is F = 0.97, with this number it can be categorized as a landslide slope. Retaining walls for slopes are used with dimensions H = 6.8 m, B = 3.8 m. The calculation of the stability of the retaining wall is calculated using 3 conditions. In normal conditions without additional load, the value of safety against rolling (Fgl) = 3.72> 2 and the value of safety against shear (Fgs) =. In normal conditions with additional loads the value of the safety factor against rolling (Fgl) = 3.32> 2 is safe, the safety factor against sliding (Fgs) = 2.53> 1.5 is safe. In earthquake conditions, the safety factor against rolling (Fgl) = 2.19> 1.25 is safe, the safety factor against sliding (Fgs) = 1.27> 1.25 is safe. For the safety factor against collapse, the safety number is 5.53> 3 safe. Reinforcement in the retaining wall is obtained for basic reinforcement using D25 ~ 250 and for reinforcing for using D16 ~ 200. Key words: Retaining walls, slopes, Fellinius Method

Item Type: Thesis (Skripsi, Tugas Akhir or Kerja Praktek) (Tugas Akhir)
Subjects: T Technology > TA Engineering (General). Civil engineering (General)
Divisions: Fakultas Sains dan Teknologi > S1 Teknik Sipil
Depositing User: Kaprodi S1 Teknik Sipil UTY
Date Deposited: 16 Oct 2020 08:26
Last Modified: 16 Oct 2020 08:26
URI: http://eprints.uty.ac.id/id/eprint/5913

Actions (login required)

View Item View Item